How to MacBook Pro A1989 Battery Replacement

This instructions to replace the glued-in battery in your MacBook Pro A1989 using an kit with adhesive remover. The adhesive remover helps weaken the glue securing the old battery, making it easier to remove, Replacing the battery on a MacBook Pro A1989 (13-inch, 2018 model) is a moderately challenging task that involves careful handling of internal components. The battery is adhered to the top case, so it requires some patience and the right tools to remove it without causing damage.

Tools and Materials Needed:

  1. Replacement battery compatible with MacBook Pro A1989
  2. Pentalobe screwdriver (P5) – for the bottom case screws
  3. Torx screwdriver (T3 or T5) – for internal screws
  4. T3 Torx driver – for the trackpad screws
  5. Spudger or plastic opening tool
  6. Tweezers
  7. Isopropyl alcohol (90% or higher) – for loosening adhesive
  8. Adhesive remover (optional) – for battery adhesive
  9. Anti-static wrist strap (recommended)
  10. Adhesive strips (if needed to secure the new battery)

Power Off and Unplug Your MacBook

Auto Boot powers on your Mac when you open the lid, and may be accidentally triggered during disassembly.Completely power off your MacBook and unplug it from any power source or peripherals.

Remove the Bottom Case

Use the Pentalobe screwdriver (P5) to remove the screws securing the bottom case. Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from to avoid damaging your device. Apply a suction handle to the lower case near the front-center area of the MacBook Pro.

Disconnect the Battery

Use a plastic spudger to disconnect the battery connector from the logic board to avoid any electrical damage during the process. Carefully peel up the large piece of tape covering the battery connector, on the edge of the logic board nearest the battery.

Remove the Trackpad Cable

Use a spudger to disconnect the trackpad ribbon cable by gently prying its connector straight up from the logic board. The trackpad cable runs over the battery and needs to be disconnected. Carefully apply the solution around the edges of the battery cells and wait a few minutes for it to penetrate the adhesive.

Remove the Battery

Press all along the edge of the tape with your spudger to stick it securely to the MacBook Pro’s aluminum case, sealing off the speaker from the battery. Gently use a plastic spudger or opening tool to lift the battery cells one by one. Start from the edges and work slowly to avoid bending or puncturing the battery cells. Continue applying adhesive remover or isopropyl alcohol as needed to help release the adhesive. If you have difficulty getting the card underneath any of the battery cells, try working a piece of floss or wire underneath the battery cell.

Pull it side-to-side in a sawing motion to separate the adhesive. Leave your plastic card in place temporarily to prevent the left-side battery cells from re-adhering. Slide the corner of one of your plastic cards underneath the top edge of one of the cells and then work it underneath the other cell. Scrape away any remaining chunks of adhesive with a plastic tool, and clean the underlying areas with adhesive remover or isopropyl alcohol.

Install the New Battery

If your battery came with adhesive pre-installed on the bottom, flip it over and carefully peel away the liner to expose the adhesive. If your battery did not come with adhesive, apply a thin double-sided adhesive tape and If the new battery does not come with adhesive, use adhesive strips to secure it in place.

After replacing the battery, it’s a good idea to calibrate it by fully charging the MacBook, then using it until the battery is completely drained, followed by a full recharge.

We hope our customers are confident that they are getting the best deal on their repair. We have a low price guarantee that promises that if you can find a lower advertised price for the same repair, we will match and beat that price. Our standard warranty is valid at Reformtech, protecting your device no matter where you need us. Description: Looking to repair your MacBook Air & Pro? We Can Fix It, From MacBook Air & Pro Screen Replacement, Battery Replacements, Keyboard & Case, Adware Removal and More.

ReformTech is a highly reliable Laptop and Smartphone repair service provider that offers on-site repairs for various brands. We specialise in fixing hardware issues, including screen replacements, keyboard replacements, RAM upgrades, SSD upgrades, and even motherboard repairs. Contact us at 8100257620 for fast and efficient service.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top
Call Now