How to Replace the Battery on the iPhone x 2025

If your iPhone X battery isn’t holding a charge like it used to, replacing it can restore performance and extend the life of your device. Follow this step-by-step guide to safely replace your iPhone X battery.

Step 1: Power Down and Remove Screws

1. Turn off your iPhone X completely.
2. Use a pentalobe screwdriver to remove the two screws located at the bottom of the device near the charging port.

Step 2: Open the iPhone X

1. Insert a razor blade or pry tool between the chassis and the edge of the screen to create a small gap.
2. Insert a plastic opening pick into the gap and slide it along the right, bottom, and left edges to loosen the adhesive.
3. The top edge should pop out naturally. Be gentle to avoid damaging the display cables.

Step 3: Secure the Display and Remove Shield Screws

1. Prop the screen up with a weighted object to prevent it from falling over.
2. Apply a few drops of isopropyl alcohol under the battery to soften the adhesive while you remove the screen.
3. Use a tri-wing screwdriver to remove the five screws securing the protective shield.
4. Lift the shield with tweezers and disconnect the battery using a plastic spudger to isolate power.
5. Disconnect the three display cables carefully and remove the screen entirely.

Step 4: Remove the Old Battery

1. Clean the chassis by removing leftover adhesive with tweezers and isopropyl alcohol.
2. Use a brush to clean dust and grime, especially near the Face ID sensors.
3. Carefully remove the adhesive pull tabs under the battery:
   • Wiggle the adhesive strip side to side while pulling to prevent breakage.
   • If an adhesive strip breaks, use a plastic pry tool to lift the battery gently.

Step 5: Install the New Battery

1. Use a TX Pro replacement battery or another high-quality option.
2. Pre-applied adhesive makes installation easier—simply peel back the pink tape.
3. Connect the battery first to ensure proper alignment, then press it firmly into place.
4. Disconnect the battery again before sealing the device.

Step 6: Reassemble the iPhone X

1. Apply a new adhesive seal along the edges of the chassis for a secure fit.
2. Reconnect the three display cables and secure the protective shield:
   • Two small screws go at the bottom.
   • The longest screw goes in the middle.
   • The slightly shorter screw goes next, followed by the remaining small screw.
3. Remove any protective films from the battery and dust seal.
4. Align the screen at the top first, then press the edges down evenly.
5. Ensure no cables are trapped between the screen and chassis before closing.

Step 7: Final Checks

1. Power on your iPhone X.
2. Reinstall the two pentalobe screws at the bottom of the phone.
3. Wipe off fingerprints and check battery health in Settings to confirm it has returned to 100%.

With these steps, your iPhone X should now have a brand-new battery, ensuring longer battery life and improved performance. If you’re unsure about any step, visit Reformtech for professional assistance. #iPhoneRepair #Reformtech #BatteryReplacement

ReformTech is a highly reliable Laptop and Smartphone repair service provider that offers on-site repairs for various brands. We specialise in fixing hardware issues, including screen replacements, keyboard replacements, RAM upgrades, SSD upgrades, and even motherboard repairs. Contact us at 8100257620 for fast and efficient service.  Best Service in Kolkata in Behala Chowrasta  with guaranteed quality. 📱🔧 #Reformtech #AppleMobileRepair #BestServiceInKolkata #iPhoneRepair iPhone service center.